DetonationEMS 1.3 Speeduino Compatible Standalone Engine Management ECU

Description

Free eBay listing template designed by dewiso.com
DetonationEMS
Budget Minded Engine Management without Compromise!
This ECU is a universal standalone engine management system! In no way is this ECU or any other universal Standalone "Plug and Play". You will need no less than detailed wiring diagrams and engine sensor information! This ECU is a Speeduino Compatible device and uses official Speeduino firmware.
The Speeduino Project is an engine management project aims to create a flexible, fully featured Engine Management Systems based on the low cost micro-controller platforms such as Arduino and STM32. All DetonationEMS ECU's are fully compatible with the the official Speeduino firmware! No code modification required! Compatible with Board Selection "Speeduino v0.4"
All hardware and firmware for Speeduino and DetonationEMS are open source!!
Included in this listing:
DetonationEMS v1.3 Board (ARDUINO NOT INCLUDED)
2.5Bar Map Sensor (Installed)
Features:
Supports up to 8 cylinders fuel and ignition using 4 channels of fuel and 4 channels of ignition outputs, 2 (Even fire only), 3 and 4 cylinder engines with full sequential fuel and ignition. 6 (even fire only) and 8 cylinder engines are supported with wasted spark and 2 squirts per cycle.
4 - Injector channels (Ground Switching)
4 - Ignition outputs (12v/5v Selectable Logic Low-Current)
4 - Fully protected input channels for CLT, IAT, TPS and O2
2 - Trigger Inputs (Crank, Cam Sensor)
1 - Optional Duel VR conditioner mount
1 - 2.5-bar Map Sensor
1 - External Map Sensor Input (Internal Map must be removed to use external pin)
1 - DRV8825 stepper module mount location for Stepper Idle Control Valves
4 - Customizable High-Current (1A max Ground Switching) Spare Outputs (Idle Valve, Boost Control, VVT, etc..)
3 - Low-Current Pre-Configured Outputs (Tachometer, Relay Control for Fan & Fuel Pump)
4 - Customizable Low-Current (400ma max Ground Switching) Spare Outputs (IDC8)
2 - Customizable Spare Analog Inputs (Oil, fuel pressure etc.. IDC8)
1 - Flex Fuel Sensor Input
1 - Clutch Switch input (Ground Switching Only)
1 - Bluetooth Header for HC-05/HC-06 Bluetooth Module (See Speeduino Wiki for setup instructions)
Firmware Capabilities:
16x16 3D fuel and ignition maps, with base of either TPS (Alpha-N) or MAP (Speed Density)
6x6 3D individual cylinder trim on engines up to 4 cylinders
After Start Enrichment
Rev limiting (Spark based, hard and soft)
Cranking specific enrichment, dwell timing and advance
General logging through Tuner Studio
High speed tooth logging
TPS calibration through Tuner Studio
Sensor calibration through Tuner Studio (Coolant, IAT and O2)
Warm Up Enrichment (WUE)
TPS based acceleration enrichment
Tach output
Fuel pump activation/deactivation (With priming)
Over dwell and over duty protection
Battery voltage compensation for dwell and injectors
Launch control
Flex fuel
O2 based Autotune (Registered version of Tuner Studio required)
Open and closed loop idle control (PWM and Stepper)
Closed loop boost control
Open loop VVT control
Deceleration fuel cut off (DFCO)
Overall Engine Protection system
Fuel and oil pressure (Using Auxiliary Analog input 5v Sensors only. See wiki)
Generic programmable outputs (See wiki)
Water and methanol injection (requires the use of additional inputs, see wiki)
Vehicle Speed in MPH & KPH Logging and Display
Each Unit is fully tested before shipping!
All Software, Firmware, Base-maps, Manuals and additional information links can be found on the Speeduino Wiki page.
Contact us
We can be contacted at any time through eBay messages if you have any questions, comments or product requests. We encourage our customers to contact us with any questions or concerns! We'd like to be sure you are completely satisfied with your purchase.
© DetonationEMS.com
E.P.A. Federal Regulations, California (CARB), other states and governing authorities prohibit sale or use of some aftermarket parts, including those that tamper with, modify or defeat emission systems in any vehicle 1966 and newer.
DetonationEMS prohibits the use of it's products on emission controlled vehicles. All parts are sold for OFF-ROAD, RACE-ONLY, GROUND-VEHICLE USE PROPOSES ONLY.